Login
You're viewing the y.diskcat.com public feed.

Replies

  • Nov 12, 2026, 4:23 PM

    current plan is:

    1. dial in and face one end of the bar square on the hackspace lathe (it's tough to do this first step precisely on the CNC)
    2. mill the other end flat & parallel
    3. mill a pocket into one end, approx 0.05mm smaller diameter than a 30mm OD bearing
    4. flip the part, mill a 60° cone
    5. cool bearing in the freezer, heat part in the oven (~90°C delta)
    6. insert bearing

    then I make a light interference fit shaft for the hearing, with threads to match the tail stock, and glue it in.

    💬 2🔄 0⭐ 0
  • Nov 12, 2026, 4:30 PM

    I'll use a tapered roller bearing since there will be some axial force when I'm pushing the tail against the stock. 32mm OD / 12mm ID seems to be a standard size, and that's perfect for this application.

    💬 1🔄 0⭐ 0
  • Nov 12, 2026, 4:34 PM

    obviously if this thing was going to be seeing a lot of force or high RPM I'd be coming up with another attachment method than "glue the shaft into the ID of the bearing" but the 4th axis is only rotating the stock at about 20rpm, and not continuously. the only reason to permanently attach the bearing to the tailstock shaft is convenience, i.e. not falling off when I'm trying to assemble the thing.

    💬 0🔄 0⭐ 0
  • Nov 12, 2026, 5:58 PM

    @gsuberland Ideally you'd cut the cone and the bearing pocket in the same setup to get concentricity for free. Can't see how to do that on a mill, though.

    💬 1🔄 0⭐ 0
  • 💬 1🔄 0⭐ 0
  • Nov 12, 2026, 6:10 PM

    @jarkman the CNC has a 3D measurement tool anyway, so as long as the bar itself isn't bent (which would be surprising given it's 40mm OD and 50mm long) and I position it on the bed with the same surfaces touching the guides (to eliminate out-of-round errors) it should end up very close to concentric.

    💬 1🔄 0⭐ 0
  • Nov 12, 2026, 6:22 PM

    @gsuberland Great, hope it goes smoothly.

    The lathe could do it if you didn't need to go down to a point - turn the cone backwards, so to speak, then part it off at the end of the cone.

    💬 1🔄 0⭐ 0
  • 💬 0🔄 0⭐ 0