jarkmanjarkman@chaos.social
Nov 12, 2026, 5:58 PM@gsuberland Ideally you'd cut the cone and the bearing pocket in the same setup to get concentricity for free. Can't see how to do that on a mill, though.
@gsuberland Ideally you'd cut the cone and the bearing pocket in the same setup to get concentricity for free. Can't see how to do that on a mill, though.
@jarkman can't see how I'd do it on a lathe either - you'd need to flip the part.
@jarkman the CNC has a 3D measurement tool anyway, so as long as the bar itself isn't bent (which would be surprising given it's 40mm OD and 50mm long) and I position it on the bed with the same surfaces touching the guides (to eliminate out-of-round errors) it should end up very close to concentric.
@gsuberland Great, hope it goes smoothly.
The lathe could do it if you didn't need to go down to a point - turn the cone backwards, so to speak, then part it off at the end of the cone.
@jarkman ah yeah good point.