@androcat @rad Now THAT would have been interesting. They would quickly realized that solar is installed once while firewood must be cut over and over again.
What first put US and UK factories on coal was the fact that unions were strong in areas with good access to water power. A lot of early factories and mechanized shops ran on water power. A preserved example of this is Pierce Mill, an 1800's automated flour mill on Rock Creek in DC. Lineshafts and belts allowed the water wheel to drive a whole lot more than just the millstones, I think the finished output was bagged flour but not sure of that.
Since early factories were water power based, this concentrated them in a few places. Water power built union power and the bosses hated paying union scale! Coal can be burned anywhere, so factories ditched the water power areas for cheap labor elsewhere. So long as nonunion labor mined the coal this worked.
By the time coal wasn't so cheap anymore, water power had been largely abandoned for running factories. The survivor of this is aluminum refiners, who use so much electricity they have traditionally been located near hydropower dams.
This BTW could have been done in a far less river-damaging way. Run the dams on a "run of the river' basis, meaning water out=water in. After Spring rains in the mountains generate high flows, put three shifts on at the plants. Stockpile finished aluminum instead of water behind the dam. Slack water in August, everyone gets a vacation and the stored aluminum is sold.