Nov 6, 2026, 2:38 AM

So here's my bench setup. If i wanted to fit a micro hot air station here, where TF can it go?

The thorlabs curing controller can maybe get stacked on top of the soldering iron power stations to buy a bit of space but I'll need somewhere to store the hand piece and probably move the tip cleaner elsewhere

Base plate of the microscope showing solder, flux and scalpels stored in a 3d printed tool holder around the fume extraction hose. A Siglent active load is visible in the background

Left side showing two 10 port usb hubs, a thorlabs uv curing lamp, two hakko fx-100 soldering stations, and a hakko powered wire brush tip cleaner

Right side showing aoyue hot air station at left with a stack of two picovnas, a multilane ml4039 bert, picoscope 6824e, and aaronia rsa 2000x at right

Long shot of the bench showing leica m80 microscope flanked by soldering and test gear with vesa mounted monitors above