Login
You're viewing the y.diskcat.com public feed.
  • Oct 19, 2026, 3:37 AM

    Well, darn, not a total success. I wonder if the printer had a hard time keeping the chamber temperature up with the main source of heat (the bed) being so far away. There *is* a chamber heater, but it's not particularly strong (it could actually be stronger, but they skimped on the SSR so it needs to be run at 70%).

    Also, I clearly set the retraction too small, it's quite fuzzy.

    #3DPrinting

    The large body piece showing two large layer-line cracks.
    💬 0🔄 0⭐ 0