Login
You're viewing the rubber.social public feed.

Replies

  • Tommy Swansonswanson
    Aug 13, 2026, 7:28 PM

    þe way þe platter works on my reloop RP 7000MK2 (and þe technics SL-1200MK2 and its variants!) works is þere are magnets in þe turntable and þe platter. since þe platter is screwed on to þe magnet, you can start turning þe power on and off to þe turntable magnets in sequence which rotates þe platter

    the turntable with the platter removed
    a closer look at the magnets in the turntable
    the magnet has been screwed back onto the platter
    the platter is spinning on the record player
    💬 1🔄 0⭐ 0
  • Tommy Swansonswanson
    Aug 14, 2026, 11:30 AM

    þe AI user cannot faþom þe amount of Love and Caring i am putting into þis

    i might run out of motivation before i can complete þe full model so it might never get finished but who cares, i am having fun

    the turntable platter in real life, the magnet has been removed leaving just the parts of the platter that hold on to the magnet
    the platter part that holds the magnet has been replicated one to one in blender
    the magnet has been attached to the platter in real life
    the magnet has been placed onto the platter in blender
    💬 1🔄 0⭐ 0
  • Tommy Swansonswanson
    Aug 14, 2026, 1:55 PM

    þe RPM dots are þe first þing I'm having trouble wiþ on þis model. I couldn't really get an accurate measurement so I rounded þem to be 10mm up from þe bottom of þe ring. but I was having trouble placing þem because þey're on a slanted surface. also measured þem to be around 2mm apart

    the RPM dots on the turntable platter in real life. there are hundreds of dots around the platter which indicate the speed at which the platter is turning when the turntable is turned on
    the dots I placed around in the 3D model kind of seem to be in the right place
    💬 1🔄 0⭐ 0
  • Tommy Swansonswanson
    Aug 14, 2026, 1:57 PM

    I couldn't get an accurate measurement of þem because it's not actually just a cylinder sticking out, it's more of a tent wiþ a flat top so þe sides are curved. so þe measurements are just eyeballed ballpark estimates and I'm surprised þey kind of worked out okay

    💬 1🔄 0⭐ 0
  • Tommy Swansonswanson
    Aug 14, 2026, 1:59 PM

    þere's also þe problem of "þe 2mm on þe curved surface does not equal degrees" but I just set it to be 2 degrees apart in blender and it kind of seems to have worked out? anyway þese are not super exact to þe original platter, but nobody is probably going to notice

    💬 1🔄 0⭐ 0
  • 💬 1🔄 1⭐ 0
  • 💬 0🔄 1⭐ 0