Login
You're viewing the functional.cafe public feed.
  • Nov 14, 2026, 7:26 PM

    Q for my #SpoonCarving people (do I have any of those?)

    I've got this little maple spoon ready for finishing. Joshua Vogel ("The Artful Wooden Spoon") tells me to boil it for 10ish minutes and then dry for a couple days before oiling. Jogge Sundqvist ("Slojd in Wood") recommends only a light spritzing of water followed by a light sanding prior to oiling.

    Anyone have any experience with boiling vs no boiling to share? I'm nervous about subjecting this little utensil to boiling, but the idea of sterilizing and stabilizing the wood sounds good.

    #woodworking #GreenWoodworking #woodcarving

    A small wooden spoon about 5" long. The wood is blonde with red-brown figure and some gray-brown patches. The handle is oval, slightly narrower than the bowl.
    Another view of the same spoon
    💬 3🔄 3⭐ 0

Replies

  • Nov 14, 2026, 7:41 PM

    @plantarum

    What did you do to the spoon to make you think you need to sterilize it?

    Mom turns wood bowls for food uses and just sands and oils them. I texted her to ask, she's a not famous master woodworker (the kind who gets invited to give demos around the country, but not considered a fine artist). I'll let you know what she says.

    💬 1🔄 0⭐ 0
  • Nov 14, 2026, 7:50 PM

    @MCDuncanLab

    nothing unusual. it's a bit of maple that had been lying in a hydro cut for a season, and the the spoon was made from the interior of the log. So I expect it will only have any fungi or bacteria that were resident in the tree before or after it was cut, or introduced from my hands or tools.

    From what I've been reading, boiling is most useful with relatively green/moist wood, as it helps to speed up the final drying process. The way I've been working this piece, slowly over a few weeks, I think it's already close to or fully dry.

    💬 0🔄 0⭐ 0
  • Nov 14, 2026, 8:04 PM

    @plantarum I don't usually make spoons but I've made the odd utensil that I cook with and do a lot with wood. I wouldn't boil it. Jogge's approach seems most sensible - raise the grain, sand it back, finish it.

    💬 0🔄 0⭐ 1
  • 💬 0🔄 0⭐ 0
  • Nov 15, 2026, 10:49 AM

    @plantarum heating the wood might also make the proteins in the wood less "tasty" for pests like insects or fungi, I don't know if that was the intention behind boiling? And it should also dry a bit faster, because hotter wood gives off more water (when the surface has be wiped dry and it's still hot)

    💬 0🔄 0⭐ 0