Login
You're viewing the functional.cafe public feed.
  • Sep 5, 2026, 11:32 AM

    @valhalla keep them in an airtight bag with desiccant and they will be fine to hand-solder whenever you get to them in future.

    In short, yes MSL is definitely a thing, and good* vendors will pop a humidity indicator card into the pack so you know if they are ready to go as soon as you receive them or not. The issue is that many plastics are hydrophilic (they like to absorb moisture from the air), especially the plastics used in LEDs. When “wet” plastic is exposed to the 260°C ambient temperature of a reflow oven, the moisture can’t evaporate quickly enough so it turns to steam and builds pressure inside plastic packages which can make them explode.

    Hand-soldering is usually fine because you don’t heat the entire package, only the leads, and you should only need a couple of seconds of heating to solder the joint instead of a typical 5 minute reflow cycle

    💬 1🔄 0⭐ 0

Replies

  • Sep 5, 2026, 12:31 PM

    @jpm thanks! that's what was felt plausible, but also I was afraid to hope :)

    There was indeed an indicator card (and dessicant) in the bag, and the leftover LEDs have been put back into it, and closed with some tape, I guess put the bag into a zip bag with some extra dessicant just to be sure. I assume that the indicator bag will say that they have been exposed to humidity the next time I'll open the bag, but then I don't have a reflow oven (and I'll avoid using the hot air station just to be sure) :D

    💬 0🔄 0⭐ 0