Login
You're viewing the functional.cafe public feed.
  • Aug 29, 2026, 12:35 AM

    I made a 3D printed pogo pin jig to spy on the data between the #SteamController and Puck. It looks like a periodic command/response burst on one of the three pins (orange) while the other pins are 5V (yellow, only active once controller is connected) and ground (gray). Currently saving the capture on my scope and then I'll decode it. I would like to get this added to #OpenPuck.

    My 3D printed pogo pin jig that is shaped to match the pogo pins on the Steam Controller Puck for connecting to the controller.  The pins are heat set with a soldering iron.
    My socket jig that replicates the pads on the back of the Steam Controller for connecting to the Puck.  I used nails to create the pads and heat set them into the plastic.  Glued two magnets to the back so it holds in place.
    The two halves connected to create a Steam Controller extension cord, I used this to test pairing the controller.
    Hooked the two halves to a breadboard to spy on the signals with my oscilloscope.
    💬 1🔄 0⭐ 0

Replies

  • Aug 29, 2026, 2:35 AM

    Looks like the signal is 56k baud rate UART, half duplex (open collector). I was playing around with PulseView trying to get it to decode the signal into something without errors and that's what lines up.

    PulseView showing the full oscilloscope capture, appears to be a command and response packet, both similar/same length.  Not sure which side initiates yet.
    Zooming in to decode the protocol as UART, it looks like 8N1 UART at 56000 baud.
    💬 1🔄 0⭐ 0
  • Aug 29, 2026, 8:44 AM

    I made some major progress. My saved scope data didn't parse the timebase correctly. It's actually standard 115200 8N1 serial. I got a working parser that can parse the puck and controller packets when hooked up to a USB to serial converter. The identoty packet (command 00) provides the controller's serial number, radio number, and firmware version. It looks like there is an input state packet (02) that provides fallback access to inputs (for menu navigation while unpaired).

    💬 0🔄 0⭐ 0