Last time I learned about networks was in the 90's - when a student instructor at university plopped a bunch of "cyberpunk" books on a table and declared that if we didn't have enough imagination to know what to do with a gigabit network connection at home, here was some inspiration.
So, I need your help, #askfedi. With #IPv6. Stopping working.
The picture is this: at home I have a simple network, consisting of a phone socket in the wall, to which the ISP's venerable Genexis PURE-ED500 ADSL router is connected. My hat-shelf server is wired to the router, and so is my access point. My laptop is connected via wifi to the access point. So far so good:
---copper--wall--router----server
\---access point~~~laptop
Everything is working in this setup - all machines have 192.168.1.* IPv4 addresses and IPv6 addresses from the ISP. In the Genexis router I have configured a rule to have the permanent IPv6 address of my server passed through; the server can be pinged and accessed from the outside, and it can access machines on the outside over IPv6.
Now, in preparation for swapping out the copper wire for optical fiber (hell will freeze over some time in September, it seems), I have bought two new pieces of hardware: a MikroTik CRS304-4XG-IN 10 GbE switch and an Asus ZenWifi BT10 access point with 10 GbE ports.
Now my setup looks like this instead:
---copper--wall--router--switch----server
\---access point~~~laptop
After this change, outgoing/incoming IPv6 stopped working on the server. It still works between the laptop and server, and it still works between the laptop and the outside.
In an attempt to troubleshoot, I moved the server back so it was connected directly to the router, instead of the new switch:
---copper--wall--router--switch----access point~~~laptop
\---server
Still IPv6 doesn't work on server, only on the laptop. I rebooted both server and old router. No change.
Then I took out the MikroTik switch completely:
---copper--wall--router----access point~~~laptop
\---server
and now IPv6 works in/out of the server again(!)
How does this compute? Somehow the MikroTik switch breaks IPv6 on the server, even though the server is not connected to the switch?
More importantly, how do I fix it? I need to twiddle something in the switch configuration? I want my local network to be 10 GbE before fiber is installed in my building :-)